|
[x]
Posted via EE Mobile
|
|
| Search, ask, and monitor your questions on the go with EE Mobile. Visit Experts Exchange from your mobile device and never be out of touch again. |
|
|
|
|
|
[x]
The Solution Rating System
|
|
| With so many solutions, how can you tell which solutions are most likely to help you and which ones are not? To provide you with a tool to use, we rate our solutions based on various elements that most accurately determine if a solution is a quality solution. To explain what factors affect the solution rating, here are the elements we take into consideration when formulating our solution rating. - The Grade of the Solution
- The Zone Rank of the Expert Providing the Solution
- The Number of Author and Expert Comments
- The Number of Experts Contributing
- The Feedback of the Community
Your Input Matters Because of the way the system is set up, the most important variable in this equation is you. As a member of Experts Exchange, you are able to cast your vote on the quality of the solutions in regard to how complete, accurate, helpful and easy to understand each solution is. When you provide your feedback, each rating is adjusted accordingly. So, if you see a solution that has a poor rating that you think is a good solution, let us know by rating it. As you do, the rating will be adjusted and will become more accurate for other members of our site. If you have any suggestions that you would like to make for our rating system, please ask a question in the Suggestions Zone of Community Support. Thank you! |
|
|
|
|
Asked by sharwani in Networking Hardware, Wireless Local Area Network, Dynamic Host Configuration Protocol (DHCP)
I am designing/installing a network for a client. They require a Office VLAN (192.168.1.0/24) and a Guest VLAN (192.168.2.0/24) which get IP addresses from 1 DHCP server. They also require a wireless LAN primarily for guest access (Guest VLAN), but if need be, it should also be able to connect to the Office VLAN. I will be using Cisco routers, switches, WLC, and APs. I've attached a network diagram that lays out my current proposed design.
I was wondering if this design would work? From what I have read, I know that I would have to enable IP helper-address on the router, but is that something I can enable through Cisco SDM? I am not very familiar with the CLI. Also, are there any drawbacks to this approach or a better design? Any feedback would be greatly appreciated.
Thank you.
20091028-EE-VQP-87 / EE_QW_2_20070628